402 Cross Paper & Clay Projects
Text

Text

#402 – Celtic Cross Paper and Clay Castings
Celebrate your Celtic heritage!
Create a unique keepsake gift, a beautiful greeting card,
a Celtic kitchen magnet, a gift box decoration, or framed wall art.
Let your imagination run wild and have fun!



Above:  A clay casting that was cut out while still wet, dried and then painted.
Below:  Examples of paper castings using 3 different techniques.
        
CLAY CASTING INSTRUCTIONS

Materials Needed:

1 Rycraft cookie stamp or craft stamp 
#402 – Celtic Cross
Clay* - we used Creative Paperlay® which air dries to a paintable pure white (no oven needed)
1 clay casting* - #402 – Celtic Cross (see Basic Clay Casting Instructions)
Sharp knife
Rub 'n Buff®: green and bronze
Optional: 1 small magnet (from craft store)
Optional: 1 piece of ribbon or wire to make an ornament hanger
Optional:  Varnish
Instructions:

1.  While clay is still wet, cut out casting using a sharp knife (see Basic Clay Casting Instructions). Let dry.
2.  Paint one coat of Rub 'n Buff green on entire casting and let dry
3.  Paint just top edges of design with bronze, so green background still shows (see closeup photo).
4.  Optional:  Apply a coat of varnish to the casting. Let dry.
5.  Optional: Glue magnet to back, or attach a hanger to make an ornament.

PAPER CASTING INSTRUCTIONS

Materials Needed:
1 Rycraft cookie stamp or craft stamp #402 – Celtic Cross
Cotton linter - (see Rycraft Paper Casting Kit and Refill)
1 paper casting* - 
#402 – Celtic Cross (see Basic Paper Casting Instructions)
Acrylic varnish
Acrylic paints (optional): burnt umber, dark brown and metallic gold for burnt casting; pale aqua and silver for white casting; and pale green and metallic gold for spice casting.
Optional:  spices of your choice to color pulp to a light tan color (see bottom photo)
Instructions:

1.  Make paper casting (either white or color it darker using spices).
2.  When paper casting is dry, apply a light coat of varnish to seal the casting from moisture (so it will not swell and lose the design when paint is applied). 
Optional: Apply a light 2nd coat of varnish and let dry.
3.  For the effects shown below:
     –   Top photo:  Apply a coat of burnt umber to entire casting and let dry. Use a flame to burn the edges of the casting.  Then apply gold paint to the top edges of the design and let dry. Optional:  Apply dark brown paint to the edges of the casting to enhance the burnt effect.
     –   Middle photo:  Apply pale aqua paint to background of cross design only and let dry. Then apply silver paint to the top edges of the design and let dry.
     –   Bottom photo:  Apply pale green paint to background of cross design only and let dry. Then apply gold paint to the top edges of the design and let dry.
4.  Apply a light coat of spray varnish to seal in paint. Let dry.
5.  Optional: Apply a 2nd coat of varnish if desired for more sturdiness. Let dry.







The castings above were designed and created by Maggie Montgomery .


Copyright © Rycraft, Inc 1978 - 2016.
Rycraft is a trademark of Rycraft, Inc.
All Rights Reserved, Chester, California